If you have been reading about GRF(1-29) and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Updated 2026-05-07. Numbers and descriptions here follow the published literature rather than marketing material.
Identity and purity are established with reversed phase high performance liquid chromatography coupled to mass spectrometry. The chromatographic step separates the target peptide from truncated sequences and deletion products, while the mass measurement confirms the expected molecular weight to within a fraction of a dalton. Because the two common variants differ by the presence of the linker, mass alone can distinguish them in the unconjugated state. Amino acid analysis and peptide mapping are used when sequence level confirmation is required.
Lyophilized material is generally stable for extended periods when held at minus twenty degrees Celsius or below and protected from moisture and light. In solution the peptide is more labile; bond hydrolysis, aggregation and oxidation of susceptible residues all proceed faster at ambient temperature. Repeated freeze and thaw cycles should be avoided because they promote clumping and loss of soluble material. The conjugated variant adds a further consideration, since the maleimide group can hydrolyze in aqueous buffer and lose its ability to react with albumin.
Laboratory handling centers on minimizing exposure to water, heat and oxygen before use. Working solutions are typically prepared in sterile water or a mild buffer, and any residual particulate matter is removed by filtration. When the powder dissolves slowly, a small proportion of acetonitrile or dilute acetic acid is sometimes added as a co-solvent. Containers are kept sealed and desiccated between uses. Records of lot number, reconstitution date and storage conditions support later comparison of results across experiments.
Reconstitution is typically performed with sterile water or bacteriostatic water, added slowly against the vial wall. The resulting solution should be clear and colorless; cloudiness or visible particles suggest a problem with the material or the diluent. Once in solution, the peptide is less stable than the dry powder. Refrigerated storage at two to eight degrees Celsius is common for short-term holding, while freezing aliquots is described for longer periods.
Purity is most often assessed by reversed-phase high-performance liquid chromatography, reported as a percentage of total peak area. Identity is confirmed by mass spectrometry, which yields a molecular ion consistent with the expected sequence. Amino acid analysis and peptide mapping provide additional characterization. Reported purity values are method-dependent, so figures from different laboratories are not always directly comparable without details of column, gradient, and detection wavelength.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off white powder | Typical lyophilized form |
| Water solubility | Soluble | May need a small organic co-solvent |
| Purity assessment | Chromatographic peak area | Most certificates report a percentage figure |
| Storage temperature | Minus 20 C or lower | Dry, dark, sealed container |
| Identity check | Electrospray mass spectrometry | Compared against theoretical mass |
CJC-1295 is the name used for a synthetic peptide modeled on growth hormone-releasing hormone, the hypothalamic signal that prompts the pituitary to release growth hormone. The compound was described by a Canadian drug discovery company in the mid-2000s as a long-acting research tool. Two closely related molecules share the name in practice: one carries a drug affinity complex, or DAC, group, and one does not. The distinction matters because the two behave differently in circulation.
The peptide backbone corresponds to GRF(1-29), the first 29 residues of native growth hormone-releasing hormone, which retains most of the receptor-activating activity of the full-length molecule. Four substitutions distinguish the analog from the natural sequence: D-alanine at position 2, glutamine at position 8, alanine at position 15, and leucine at position 27. These changes slow cleavage by dipeptidyl peptidase IV, the enzyme that degrades native hormone in plasma within minutes. The outcome is improved enzymatic stability combined with a still brief residence time when no additional modification is present.
Naming in this area is inconsistent, and readers should treat product labels with care. In much of the literature and in vendor catalogs, the unqualified term refers to the albumin-binding version, while the version lacking the DAC group appears as modified GRF(1-29), mod GRF(1-29), or the same name with a without-DAC qualifier. Because one abbreviation has been applied to both materials, the only reliable way to identify a sample is to check the stated sequence and the presence of the linker.
Characterization of this peptide relies on a small set of routine techniques. Reversed-phase high-performance liquid chromatography separates the target from truncated or oxidized by-products and yields a purity estimate when paired with ultraviolet detection near 214 nanometers. Mass spectrometry, either electrospray coupled to liquid chromatography or matrix-assisted laser desorption, confirms that the observed mass matches the value calculated for the expected sequence. Amino acid analysis, and enzymatic digestion followed by fragment mapping, are used when the sequence itself rather than the mass requires verification.
Stability depends heavily on physical state. A lyophilized powder kept dry, desiccated, and shielded from light typically holds its integrity for months to years at minus twenty degrees Celsius, and longer at minus eighty. Once dissolved, the peptide becomes far more vulnerable, since peptide bond hydrolysis, oxidation of susceptible residues, and aggregation all proceed faster in solution. Buffers near neutral pH are generally gentler than strongly acidic or alkaline conditions. Repeated freeze-thaw cycles and exposure to air-liquid interfaces during vigorous mixing cause losses that are easy to overlook.
Verification matters because research peptides vary widely in quality. A certificate of analysis is only as reliable as the method behind it, and a single chromatographic trace reveals little about counter-ions, residual solvents, or water content. Independent laboratories commonly pair mass confirmation with chromatographic purity and, where relevant, quantify water along with acetate or trifluoroacetate content. Reported purity figures are not standardized across suppliers, so a stated value such as ninety-eight percent is not directly comparable unless the analytical method, column, and detection wavelength accompany it.
The dividing feature between the two forms is a maleimide-based drug affinity complex, abbreviated DAC. In the DAC-bearing version, a linker attaches the peptide to serum albumin after administration, and that association slows removal from plasma. The version lacking DAC appears in catalogs as MOD GRF(1-29) or tetrasubstituted GRF(1-29). Because informal writing treats both as one item, comparisons drawn from such sources routinely blend measurements taken from two molecules with substantially different behavior.
Four amino acid substitutions separate the modified backbone from the parent GRF(1-29) sequence. These changes reduce recognition by dipeptidyl peptidase IV and related proteases, extending the interval before degradation. Development work in this area sought longer-acting GHRH analogs for endocrine investigation. Published descriptions treat the substitution set as a defining property of the core sequence, while the albumin-binding linker is described separately as an optional addition to that same backbone.
The DIT and other forms of digital mass analyzers scan ions by scanning the frequency of the drive waveform. The AC voltage is typically fixed during the scan. Digital devices use a duty cycle which allows them to operate completely independent of a DC voltage and without resonant excitation. When the DC voltage is zero the parameter a is also zero. Consequently, ion stability will depend on q. With these considerations it was possible to design a new type of stability diagram that is more suitable for planning and performing experiment. In 2014 Brabeck and Reilly created a stability diagram that maps the range of stable mass-to-charge ratios, m/z to the corresponding range of drive frequencies based on several user inputs. For a particular duty cycle, the operator can quickly reference the range of stable masses at each frequency of a scan. Fig 4 (a) and (b) shows the frequency-m/z stability diagram for a linear DIT with a duty cycle of d = 0.50 and d= 0.60 respectively.
==== MeSH D13.695.740 – pyrimidine nucleotides ==== MeSH D13.695.740.050 – apurinic acid MeSH D13.695.740.246 – cytosine nucleotides MeSH D13.695.740.246.050 – arabinofuranosylcytosine triphosphate MeSH D13.695.740.246.115 – cyclic cmp MeSH D13.695.740.246.150 – cytidine diphosphate MeSH D13.695.740.246.150.180 – cytidine diphosphate choline MeSH D13.695.740.246.150.210 – cytidine diphosphate diglycerides MeSH D13.695.740.246.370 – cytidine monophosphate MeSH D13.695.740.246.370.250 – cytidine monophosphate n-acetylneuraminic acid MeSH D13.695.740.246.400 – cytidine triphosphate MeSH D13.695.740.246.425 – deoxycytosine nucleotides MeSH D13.695.740.246.425.300 – deoxycytidine monophosphate MeSH D13.695.740.600 – pyrimidine dimers MeSH D13.695.740.706 – thymine nucleotides MeSH D13.695.740.706.788 – thymidine monophosphate MeSH D13.695.740.850 – uracil nucleotides MeSH D13.695.740.850.210 – deoxyuracil nucleotides MeSH D13.695.740.850.210.200 – fluorodeoxyuridylate MeSH D13.695.740.850.600 – uridine diphosphate MeSH D13.695.740.850.600.677 – uridine diphosphate sugars MeSH D13.695.740.850.600.677.100 – uridine diphosphate n-acetylgalactosamine MeSH D13.695.740.850.600.677.120 – uridine diphosphate n-acetylglucosamine MeSH D13.695.740.850.600.677.150 – uridine diphosphate n-acetylmuramic acid MeSH D13.695.740.850.600.677.300 – uridine diphosphate galactose MeSH D13.695.740.850.600.677.350 – uridine diphosphate glucose MeSH D13.695.740.850.600.677.375 – uridine diphosphate glucuronic acid MeSH D13.695.740.850.600.677.800 – uridine diphosphate xylose MeSH D13.695.740.850.877 – uridine monophosphate MeSH D13.695.740.850.877.500 – sofosbuvir MeSH D13.695.740.850.950 – uridine triphosphate
Technetium-99m's short half-life of 6 hours makes long-term storage impossible. Transport of 99mTc from the limited number of production sites to radio pharmacies (for manufacture of specific radiopharmaceuticals) and other end users would be complicated by the need to significantly overproduce to have sufficient remaining activity after long journeys. Instead, the longer-lived parent nuclide 99Mo can be supplied to radio pharmacies in a generator, after its extraction from the neutron-irradiated uranium targets and its purification in dedicated processing facilities. Radio pharmacies may be hospital-based or stand-alone facilities, and in many cases will subsequently distribute 99mTc radiopharmaceuticals to regional nuclear medicine departments. Development in direct production of 99mTc, without first producing the parent 99Mo, precludes the use of generators; however, this is uncommon and relies on suitable production facilities close to radio pharmacies.
== Indications == It is a highly selective dipeptidyl peptidase-4 inhibitor that is typically used as an add on treatment when the first line treatment of metformin is not achieving the expected glycemic goals; though it has been approved for use as a first line treatment when metformin cannot be used.
Sources: en.wikipedia.org
Like other AASs, oxandrolone is an agonist of the androgen receptor, similar to androgens such as testosterone and DHT. The relative binding affinity of oxandrolone for the androgen receptor is about 0.3% of that of metribolone. Activation of the androgen receptor stimulates protein synthesis, which increases muscle growth, lean body mass, and bone mineral density. Compared to testosterone and many other AASs, oxandrolone is less androgenic relative to its strength as an anabolic. Oxandrolone has as much as six times the anabolic potency of testosterone and has significantly reduced androgenic potency in comparison: oxandrolone exhibits significantly lower virilizing androgenic properties compared to testosterone, with a relative androgenic potency of only 5%. Compared to methyltestosterone, oxandrolone has about 322 to 633% of the anabolic potency and 24% of the androgenic potency. The reduced ratio of anabolic to androgenic activity of oxandrolone motivated its medical use in children and women because less androgenic effect implies less risk of virilization. The bodybuilding community also considers this fact when choosing between AASs. As of 2003 and 2011 Oxandrolone was thought to be "uniquely" far less hepatotoxic than other 17α-alkylated AASs, which was thought to be due to differences in metabolism. This turned out not to be the case in the long run, which is why it was taken off the US market in 2023.
The four substrates of this enzyme are 4-hydroxybenzoic acid, reduced nicotinamide adenine dinucleotide (NADH), oxygen, and a proton. Its products are protocatechuic acid, oxidised NAD+, and water. Nicotinamide adenine dinucleotide phosphate can be used as an alternative cofactor. The enzyme is a flavin-containing monooxygenase that uses molecular oxygen as oxidant and incorporates one of its atoms into the starting material. The systematic name of this enzyme class is 4-hydroxybenzoate,NAD(P)H:oxygen oxidoreductase (3-hydroxylating). Other names in common use include 4-hydroxybenzoate 3-monooxygenase (reduced nicotinamide adenine, dinucleotide (phosphate)), 4-hydroxybenzoate-3-hydroxylase, and 4-hydroxybenzoate 3-hydroxylase. This enzyme participates in benzoate degradation via hydroxylation and also uses flavin adenine dinucleotide as a cofactor.
=== Cancer-related === Translationally controlled tumor protein has a role in tumor reversion and development. TCTP is a regulator of the cancer stem cell compartment, the tumor reversion, tumor progression and certain forms of inflammatory diseases. Moreover, TCTP was described as a pro-survival protein antagonizing BAX function.
Sources: en.wikipedia.org
The mass difference from the linker is large enough for routine detection by mass spectrometry. The unconjugated form gives a single sharp signal at its expected weight. Material that has already reacted with albumin shows a much higher mass and a broadened chromatographic peak.
Yes. Degradation proceeds faster once the powder is dissolved, especially at room temperature or after multiple freeze and thaw cycles. Working solutions are often aliquoted to avoid repeated handling. Lyophilized powder held cold and dry retains its properties far longer.
Truncated sequences, oxidized residues and aggregated forms can all elute near the main peak. Reversed phase chromatography resolves many of these species, so the number of peaks is a useful indicator of synthesis quality. A single peak does not by itself prove correct sequence, which is why mass confirmation is paired with it.
Cool, dark, and dry conditions are standard, with storage at minus twenty degrees Celsius or below. Desiccant and sealed vials limit moisture uptake. Repeated warming and cooling of the container is generally avoided.